AERMOTOR Relay Tester 能够快速的检测出你的继电器是否正常，使用简单，适用于市面的汽车继电器，支持12V和24V继电器测试.
测试时，设备需要连接到12V-24V的汽车电瓶上。测试时根据继电器的脚位把开关拨到4PIN或者5PIN.按下测试按钮后测试仪亮绿色LED灯并且闪烁说明继电器正常，如果按下测试按钮亮红色LED灯说明继电器不正常。
操作说明：
1 测试时把红色夹子夹到电瓶正极，黑色夹子则夹到电瓶负极
2 测试12V继电器时需要连接到12V电瓶上，测试24V继电器时需要连接到24V的电瓶上。
3接入电源后设备亮红灯既可以插入继电器
4测试4脚继电器把开关拨到4PIN,测试5脚继电器把开关拨到5PIN
5接入继电器调好脚位开关后就可以按下按钮
6测试时脚位不对或者继电器损坏了，测试就会亮红色LED灯。
7当脚位设置正确时，测试仪会亮绿色LED灯并且闪烁10次绿灯则表示继电器正常。
Product Introduction:

AERMOTOR Relay Tester can quickly detect whether your relay is working properly. It is easy to use and suitable for automotive relays on the market. It supports 12V and 24V relay testing

During testing, the equipment needs to be connected to a 12V-24V car battery. When testing, turn the switch to 4PIN or 5PIN according to the relay's pin position. Press the test button and the tester will light up the green LED and flash, indicating that the relay is working. If the test button is pressed and the red LED is on, it indicates that the relay is not w orking.

Operating instructions:

During the test, clamp the red clip onto the positive pole of the battery, while the black clip onto the negative pole of the battery

When testing a 12V relay, it needs to be connected to a 12V battery, and when testing a 24V relay, it needs to be connected to a 24V battery.

After connecting to the power supply, the device turns on a red light, which allows for the insertion of a relay

Test the 4-pin relay to set the switch to 4PIN, and test the 5-pin relay to set the switch to 5PIN

After connecting the relay and adjusting the foot switch, you can press the button

During the 6 test, if the foot position is incorrect or the relay is damaged, the red LED will light up during the test.

When the foot position is set correctly, the tester will light up the green LED and flas

产品列表
1：主机
2：说明书
3；泡沫袋
4：彩盒包装